To clean a Puffco peak atomizer, you will need to remove the glass mouthpiece and the atomizer coil. You can then soak the atomizer coil in isopropyl alcohol for a few minutes before rinsing it off. You can then use a pipe cleaner to clean out the inside of the glass mouthpiece.
The Puffco Peak Pro can be soaked in isopropyl alcohol (IPA) to clean it. You can either soak the entire atomizer in IPA or you can soak the atomizer’s coil in IPA. Soaking the atomizer’s coil in IPA is the best way to clean it because it will remove any built-up resin from the coil.
Yes, you can soak the Puffco Plus atomizer. To do so, remove the atomizer from the pen and soak it in a bowl of isopropyl alcohol for about 15 minutes. Then, rinse it off with water and let it dry completely before putting it back in the pen.
To deep clean a Puffco Peak, you will need 91% isopropyl alcohol, a cotton swab, and a bowl. Pour the alcohol into the bowl and dip the cotton swab into it. Swipe the cotton swab along the inside of the Peak until it is clean.How do you take apart a Puffco atomizer?
The atomizer on the Puffco peak can be fixed by following these steps:Turn the Puffco peak off and disconnect it from the power supply.Remove the mouthpiece and unscrew the atomizer from the top of the battery.Clean any debris or residue from the threads of the atomizer and the battery.Reattach the atomizer to the battery and screw it in place.
The Puffco Peak Pro atomizer usually lasts around 2-3 weeks with regular use.
Yes, you can soak an atomizer in alcohol. This will help clean the atomizer and remove any built-up residue. Be sure to rinse the atomizer thoroughly after soaking it in alcohol.
There are a few reasons why your Puffco peak might be blinking. One possibility is that you have run out of battery and need to recharge it. Another possibility is that the temperature is too high or too low, and the device is trying to adjust it. If neither of those reasons seem to be the issue, then it’s possible that there is something wrong with the device and you should contact Puffco support.
The Puffco Peak Pro is blinking red and blue because it needs to be charged. The light will stop blinking when the Peak Pro is fully charged.
To change the atomizer on the Puffco Peak Pro, you first need to remove the mouthpiece. To do this, hold the Peak Pro with one hand and use your other hand to twist the mouthpiece counterclockwise. Once it’s loose, pull it straight off.Next, you’ll need to unscrew the top of the atomizer. There are three small screws on the top – use a small Phillips head screwdriver to remove them.
Atomizers can be dismantled by removing the screws that hold the metal parts together. The metal parts can then be separated and the coil and wick can be removed from the base.
If your atomizer is bad, you’ll likely experience poor performance and/or a decrease in vapor production. One way to test if your atomizer is bad is to try another atomizer in your Puffco Plus. If the performance is improved, then you know that your atomizer is bad.
