No, the Puffco Peak Pro atomizer cannot be soaked.
Peak atomizers are designed to be easy to take apart and clean. To remove the atomizer, unscrew the two screws that hold the atomizer in place. Then, pull the atomizer out of the battery housing. To clean the atomizer, use a q-tip and some rubbing alcohol.
The Puffco Peak Pro atomizer should last around 1.5 to 2 hours depending on how often you take a puff.
To clean a Puffco atomizer, first remove the battery by unscrewing the bottom of the unit. Next, remove the atomizer by unscrewing the top. Finally, wash all parts in warm water and soap.
To clean your Puffco plus atomizer, unscrew the top cap and remove the atomizer. Rinse it with warm water and a mild soap. Replace the atomizer and screw the top cap back on.
Peak Pro disassembles into four main parts: the handle, the base, the battery, and the sensor. To take it apart, start by removing the handle. On each side of the handle there are two screws that you can remove with a Phillips head screwdriver. Once those are out, you can lift off the handle. Underneath it is a small circuit board that you can remove by popping out two small screws.
The Puffco Peak should be cleaned every 3 months.
There are a few ways to fix a Puffco Peak Pro chamber. The most common way is to blow out the chamber using compressed air. Another way is to remove the chamber and clean it out.
There are a few things that you can do in order to fix an atomizer on a Puffco Peak. The first thing is to try and unscrew the atomizer from the battery. If that doesn’t work, you can try using a screwdriver to pry it off. If that still doesn’t work, you can try using a razor to cut through the atomizer.
The first thing to do is to try a new atomizer. If the problem persists, you may need to replace the atomizer.
Unfortunately, 70% is not enough to effectively clean a Puffco atomizer. You would need at least 95% alcohol to be effective.
Peak coils typically last around 6 months before they need to be replaced.
