It’s not recommended to get your longboard wet, but it’s not going to hurt it if it does. If you do get your longboard wet, just make sure to dry it off as soon as possible.

Cleaning your longboard should be done every time you use it. If you don’t use it for a while, give it a good cleaning with soap and water.

There are a few ways to clean longboard parts. You can use soap and water, a cleaner specifically designed for longboards, or a degreaser. It’s important to be careful when cleaning longboard parts because they can be delicate and easily damaged.

The best way to clean a rusty longboard is to use a pressure washer.

There are a few ways to protect your longboard from water. One is to cover it with a tarp or a sheet when not in use. Another is to put a waterproof coating on the board. And finally, you can buy a waterproof case for your board.

Yes, you can power wash a longboard. Be sure to use a strong detergent and scrub the entire board with a hard-bristled brush. Use a hose to rinse the board off and dry it off completely before storing it.

Bearing replacement is typically recommended every 6 months for longboards under 50 inches in length and every year for boards over 50 inches.

WD40 is not bad for skateboard bearings, but it is not good either. It can help to remove dirt and debris, but it will not protect the bearings from wear.

There are a few ways to get rust off your skateboard. You can use a wire brush, steel wool, or a scouring pad. You can also use aRustoleum Rusty Metal Cleaner.

Yes, isopropyl alcohol can clean bearings. However, it is important to note that isopropyl alcohol can also damage bearings if used incorrectly.

A waterlogged skateboard will typically have a lot of water on the deck, trucks, and wheels. The bearings may also be wet, and the grip tape may be sticking to the deck.

There is no definitive answer to this question since it depends on the wind speed and direction. If the wind is light and blowing from the side, you may be able to longboard in it. However, if the wind is stronger and coming from behind you, it will be difficult to stay balanced and stay on your board.

There are a few ways to seal a longboard. You can use a heat gun, an air compressor, or a hair dryer.