The filter is located on the bottom of the washing machine.
Some top loading washing machines have filters to clean, while others do not. It depends on the model of the machine. If you are unsure if your machine has a filter, consult your owner’s manual.
The lint filter on your Kenmore top load washer is located on the right side of the machine, at the bottom. To clean it, remove the filter and rinse it under running water. You can also use a brush to scrub off any built-up lint. Reinstall the filter and run the washer on a short cycle to rinse it out.
To clean the filter on your Kenmore washing machine, you will need to remove the front panel of the machine. Once the panel is removed, you will be able to access the filter and clean it as needed. Be sure to refer to your owner’s manual for specific instructions on how to access and clean the filter on your machine.
Yes, there is a filter on a Kenmore washing machine. The filter is located on the bottom of the machine and it is used to trap lint and other debris. It is important to clean the filter regularly to ensure that the machine operates properly.
The filter is located at the bottom of the washing machine. It catches any debris or lint that may have been washed into the machine.
The lint trap is typically located on the front of the washer, below the door.
The coin trap is the small opening on the front or back of a top-loading washing machine where you put your coins to start the wash cycle.
If you’re dealing with a small amount of lint, you can try to remove it by hand. Start by unplugging the washer and emptying it of any water. Use a soft brush or your hands to remove as much of the lint as possible. If there’s still some left behind, you can try using a vacuum cleaner to suck it up.
The washer filter is located on the bottom of the machine. It’s a small, cylindrical filter that can be removed for cleaning.
To clean the filter on a Whirlpool top load washer, you’ll need to remove the front panel. The filter is located in the lower right corner of the washer. You can use a screwdriver to remove the screws that hold the panel in place. Once the panel is removed, you can clean the filter with a brush or a vacuum cleaner.
